H22 Head Bolt Torque Sequence. boosted honda prelude h22! you can download the manual for free in pdf form here: (2.1 us qt, 1.7 imp qt) (at overhaul) rule of thumb:*with vehicle level and filler bolt removed, fill until honda mtf drips out of top. Lbs.) axle nut tightening specifications front 245 nm (181 ft. i've been searching and cannot for the life of me find any torque specs for an h22 head. if you are putting a 95 or newer h22a in the car then you'll need a p13ecu to run the vtec. Yes, i've searched, a ton. hey im new to this site and i asked people on other sites if they had bolt torque specs for the h22 motors. Fresh head installed torque to spec. Lbs.) rear bottom bolt 64 nm (47 ft. You can have it checked with a straight. John grether no problem, i can.if the engine overheated badly then its very likely that the head is warped. You'll also need to run power to the vtec solenoid.
i've been searching and cannot for the life of me find any torque specs for an h22 head. You can have it checked with a straight. boosted honda prelude h22! (2.1 us qt, 1.7 imp qt) (at overhaul) rule of thumb:*with vehicle level and filler bolt removed, fill until honda mtf drips out of top. Fresh head installed torque to spec. Lbs.) rear bottom bolt 64 nm (47 ft. You'll also need to run power to the vtec solenoid. John grether no problem, i can.if the engine overheated badly then its very likely that the head is warped. hey im new to this site and i asked people on other sites if they had bolt torque specs for the h22 motors. if you are putting a 95 or newer h22a in the car then you'll need a p13ecu to run the vtec.
Head Bolts Torque Sequence? My Haynes Manual Says to Tighten the
H22 Head Bolt Torque Sequence (2.1 us qt, 1.7 imp qt) (at overhaul) rule of thumb:*with vehicle level and filler bolt removed, fill until honda mtf drips out of top. i've been searching and cannot for the life of me find any torque specs for an h22 head. John grether no problem, i can.if the engine overheated badly then its very likely that the head is warped. Lbs.) axle nut tightening specifications front 245 nm (181 ft. You can have it checked with a straight. boosted honda prelude h22! hey im new to this site and i asked people on other sites if they had bolt torque specs for the h22 motors. Lbs.) rear bottom bolt 64 nm (47 ft. You'll also need to run power to the vtec solenoid. (2.1 us qt, 1.7 imp qt) (at overhaul) rule of thumb:*with vehicle level and filler bolt removed, fill until honda mtf drips out of top. Fresh head installed torque to spec. Yes, i've searched, a ton. if you are putting a 95 or newer h22a in the car then you'll need a p13ecu to run the vtec. you can download the manual for free in pdf form here: